Products
 
 
  Photo Gallery
 














 
                  Potassium Silimor™ Mortar. (Acid Resistant Mortar)
 
Potassium Silicate Mortar is widely used for Acid Resistant Bricks & Tiles lining works as Bedding & Jointing Mortar for Tanks, Floor, Drain, Foundation etc.
 
 
 
  Resistant:  
 
    It is resistant to Oxidizing & Non-oxidizing Acids, & Chlorine Gas except Hydrofluoric Acid.
 
  Resistant to temperature:  
 
    1000° C  (Max.)
 
  Preparation of Mortar:  
 
    Preparation of Mortar generally consists of Solution & Powder. In order to obtain good working consistency, the average mixing ratio is 1 Pbw of Solution & 3 pbw of Powder. This ratio will slightly vary depending upon the temperature and working conditions.

    Prepare small batches of Mortar. Stirrer the Solution thoroughly before use. Place the Solution in a suitable mixing pan and add powder in it. Mix thoroughly with a spatula or Trowel. The mixing operation shall be continued until a uniform mixture is obtained.

    Make sure that all the Mortar is used from the mixing pan before another batch is prepared.

    Surface Preparation:

    The cement plastered surface shall be slightly rough in line & level , dry & clean, free from dust, dirt, grease, oil etc., maintaining required slope etc. as no slope can be adjusted or altered in Acid proof lining works.

    Setting/Curing:

    Furomor Resin Mortar is a Self-hardening due to its chemical reaction which occurs when the Powder & Resin are mixed together.

    An initial setting occurs in 6 to 8 hrs. at 30°C
       Final Setting occurs in 24 to 48 hrs. at  30°C
       Curing time: 7 days at  30oC

    Please ensure that no water shall be spilled over the bricks lining works before it completely cured.
 
                  Potassium silimor™ mortar cond.. (Acid Resistant Mortar)  
   
  Acid Curing:  
     
 
    When the bedding & jointing mortar is different, after the bedding mortar is properly set, cure the joints for a minimum period of 72 hours with 20 to 25% HCL acid before applying the resin type mortar. After acid curing, wash the free acid in the joints with clean water & allow sufficient time for thorough drying. Resin mortar shall then be filled into the joints.
 
     
  Mechanical/Physical property:  
     
 
Working time at 30 oC     : 20 minute (min)
Density of cured mortar : 2 grm per cc
Bond strength       : 5 Kg.Cm2
Compressive Strength     : 150 Kg/Cm2
Flexural Strength : 40 Kg/Cm2
Toluene Absorption : Max. 18%
 
     
  Storage Life  
 
    Solution : 24 Months at the temperature 30°C (+2°C)
    Solution : 24 Months at the temperature 30°C (+2°C)

    All two components are stored in cool and dry place under the roof until ready to use it original unopened (Sealed) containers.
 
  Packing  
 
    Solution    : 75 Kg. in M.S. Drum

    Powder     : 50 Kg. in Plastic Bag.
 
  Export packing  
 
    ( As per customer’s requirement)