Potassium Silimor Mortar

Resistant:

• It is resistant to Oxidizing & Non-oxidizing Acids, & Chlorine Gas except Hydrofluoric Acid.

Resistant to temperature :

• 1000° C (Max.)

Preparation of Mortars :

• Preparation of Mortar generally consists of Solution & Powder. In order to obtain good working consistency, the average mixing ratio is 1 Pbw of Solution & 3 pbw of Powder. This ratio will slightly vary depending upon the temperature and working conditions.
• Prepare small batches of Mortar. Stirrer the Solution thoroughly before use. Place the Solution in a suitable mixing pan and add powder in it. Mix thoroughly with a spatula or Trowel. The mixing operation shall be continued until a uniform mixture is obtained.
• Make sure that all the Mortar is used from the mixing pan before another batch is prepared.

Surface Preparation:

• The cement plastered surface shall be slightly rough in line & level , dry & clean, free from dust, dirt, grease, oil etc., maintaining required slope etc. as no slope can be adjusted or altered in Acid proof lining works.

Setting/Curing:

• Silimor Resin Mortar is a Self-hardening due to its chemical reaction which occurs when the Powder & Resin are mixed together.
• An initial setting occurs in 6 to 8 hrs. at 30°C
• Final Setting occurs in 24 to 48 hrs. at  30°C
• Curing time: 7 days at  30oC
• Please ensure that no water shall be spilled over the bricks lining works before it completely cured.

Potassium silimor mortar cond.. (Acid Resistant Mortar)

Acid Curing:

When the bedding & jointing mortar is different, after the bedding mortar is properly set, cure the joints for a minimum period of 72 hours with 20 to 25% HCL acid before applying the resin type mortar. After acid curing, wash the free acid in the joints with clean water & allow sufficient time for thorough drying. Resin mortar shall then be filled into the joints.

Mechanical/Physical property:

• Working time at 30 oC  : 20 minute (min)
• Density of cured mortar : 2 grm per cc
• Bond strength : 5 Kg.Cm2
• Compressive Strength   : 150 Kg/Cm2
• Flexural Strength : 40 Kg/Cm2
• Toluene Absorption : Max. 18%

Storage Life

• Solution : 24 Months at the temperature 30°C (+2°C)
• Solution : 24 Months at the temperature 30°C (+2°C)

All two components are stored in cool and dry place under the roof until ready to use it original unopened (Sealed) containers.

Packing

• Solution : 75 Kg. in M.S. Drum
• Powder : 50 Kg. in Plastic Bag.

Export packing

• (As per customer’s requirement)